This Electric Hydraulic Crusher is designed for Tractor, Trailer and Truck Oil Filters up to 16"High x 9"Diameter
The Electric Hydraulic Crusher is manufactured to be used with an optional Oil Filter Crusher Stand.
- Reduces filters by 75% of original size, and removes 95% of the free-flowing oil so it can be recycled.
- Large crushing chamber: accepts filters up to 16″ tall x 9″ diameter.
- Automatic crushing cycle.
- Cycle time: 1 minute.
- Pump: 1 Phase/ 230V/60Hz or 1 Phase 220V/50Hz.
- Safety door – crusher will not operate if door is opened.
- Overall size on optional stand: 87″ high, 23″ wide, 31″ deep.
- Size: 50″ high, 18″ wide, 31″ deep.
- Crusher weight 404 lbs.
- Part No: WO8215BJ
Easy Installation
NOTE: Always adhere to installation / usage instructions and warning. Improper use may result in injury, damage or hazardous spill.
- Bolt crusher stand with vibration pads to the floor. Tighten bolts firmly, approximately 1 to 2 turns past hand tight – do not overtighten.
- Place crusher on stand.
- Bolt crusher to stand using four 1/2" x 2" bolts, 1/2" nuts, and 1/2" locking washers (provided). Tighten firmly, approximately 1 to 2 turns past hand tight – do not overtighten.
- Connect drain hose and adapter to the bottom of the crusher – tighten firmly, approximately 1 to 2 turns past hand tight – do not overtighten.
- Place waste oil recovery drum underneath crusher stand.
Operation Instructions
OPENING THE DOOR WILL INTERRUPT POWER TO THE POWER UNIT
NOTE: The power unit is a 230v/60Hz single-phase motor.
- Turn the power switch to the ON position.
- Open crusher door.
- Place filter (open end face down) in the center of the crushing chamber.
- Close crusher door.
- Raise and lock both levers on the main valve in the up position.
- Depress and hold the starter switch for three seconds then release.
- Wait for crusher to complete the crushing cycle (will automatically turn off power unit).
- Open crusher door.
- Confirm crusher ram has fully retracted.
- Remove crushed filter.