Electric Hydraulic Crusher with Stand for Tractor, Trailer and Truck Oil Filters

This Electric Hydraulic Crusher is packaged with a Large Crusher Stand and is designed for Tractor, Trailer and Truck Oil Filters up to 16"High x 9"Diameter

Electric Hydraulic Oil Filter CrusherElectric Hydraulic Oil Filter CrusherElectric Oil Filter Crusher FeaturesElectric Filter Crusher Specifications


  • Reduces filters by 75% of original size, and removes 95% of the free-flowing oil so it can be recycled.
  • Large crushing chamber: accepts filters up to 16″ tall x 9″ diameter.
  • Automatic crushing cycle.
  • Cycle time: 1 minute.
  • Pump: 1 Phase/ 230V/60Hz or 1 Phase 220V/50Hz.
  • Safety door – crusher will not operate if door is opened.
  • Overall size on stand: 87″ high, 23″ wide, 31″ deep.
  • Crusher Size: 50″ high, 18″ wide, 31″ deep.
  • Crusher weight with stand 516 lbs.
  • Part No: WO7720BJ5525SR

Easy Installation

NOTE: Always adhere to installation / usage instructions and warning. Improper use may result in injury, damage or hazardous spill.

  1. Bolt crusher stand with vibration pads to the floor. Tighten bolts firmly, approximately 1 to 2 turns past hand tight – do not overtighten.
  2. Place crusher on stand.
  3. Bolt crusher to stand using four 1/2" x 2" bolts, 1/2" nuts, and 1/2" locking washers (provided). Tighten firmly, approximately 1 to 2 turns past hand tight – do not overtighten.
  4. Connect drain hose and adapter to the bottom of the crusher – tighten firmly, approximately 1 to 2 turns past hand tight – do not overtighten.
  5. Place waste oil recovery drum underneath crusher stand.

Operation Instructions

OPENING THE DOOR WILL INTERRUPT POWER TO THE POWER UNIT
NOTE: The power unit is a 230v/60Hz single-phase motor.

  1. Turn the power switch to the ON position.
  2. Open crusher door.
  3. Place filter (open end face down) in the center of the crushing chamber.
  4. Close crusher door.
  5. Raise and lock both levers on the main valve in the up position.
  6. Depress and hold the starter switch for three seconds then release.
  7. Wait for crusher to complete the crushing cycle (will automatically turn off power unit).
  8. Open crusher door.
  9. Confirm crusher ram has fully retracted.
  10. Remove crushed filter.

newspaper templates - theme rewards